Load:auto; [:State]; Auto - Agilent Technologies E1445A User's Manual And Scpi Programming Manual

:LOAD:AUTO

Parameters
Comments
Example

[:STATe]

Parameters
Comments
Example
Chapter 8
OUTPut[1]:LOAD:AUTO <
should be coupled to (track) the
Parameter Parameter
Name
< mode > boolean
With OUTPut[1]:LOAD:AUTO ON
the OUTPut[1]:IMPedance
value. Specifying a value for
LOAD value to the IMPedance
Executable when Initiated: Yes
Coupling Group: Voltage
Related Commands: OUTPut[1]:IMPedance
*RST Condition:
OUTPut1:LOAD:AUTO ON
Uncoupling
OUTPut[1]:IMPedance
OUTP:LOAD:AUTO OFF
OUTPut[1][:STATe] < mode
enable or disable the analog output. Disabling the output does not stop waveform
generation; however, the output appears as an open circuit.
Parameter Parameter
Name
mode boolean
< >
Executable when Initiated: Yes
Coupling Group: None
*RST Condition: OUTPut1:STATe ON
Disabling the Output
OUTP OFF
mode > indicates whether the
OUTPut[1]:IMPedance
Range of
Type Values
OFF | 0 | ON | 1 | ONCE
set, the OUTPut[1]:LOAD
value. Changing the
sets
LOAD AUTO OFF
value and sets AUTO OFF
, OUTPut[1]:LOAD
and
OUTPut[1]:LOAD
Uncouples impedance and load.
> closes or opens the Agilent E1445A's output relay to
Range of
Type Values
OFF | 0 | ON | 1
(not SCPI compliant)
Disables output.
OUTPut[1]
OUTPut[1]:LOAD
value.
Default
Units
none
value is coupled to
IMPedance changes the LOAD
. sets the
AUTO ONCE
.
Default
Units
none
Command Reference
value
311