C.6.9 Network Processor (Np) Interface Commands / Queries - Comtech EF Data SLM-5650A Installation And Operation Manual

SLM-5650A Satellite Modem
Appendix C
C.6.9 Network Processor (NP) Interface Commands / Queries
The instruction codes that follow are valid only when the optional Network Processor (NP) Interface Module is installed in the SLM-5650A Satellite
Modem.
Command Arguments for
Parameter (Instruction
Type Code and
Qualifier)
Router Ethernet BRT= 1 byte, value of
Interface Traffic 0 or 1
IP Address and
Range
Router Working GBM= 1 byte
Mode
Router Ethernet MIP= 18 bytes
Interface
Management IP
Address and
Range
Modem IP MIS= 1 byte, value of
Interface 0 or 1
Security Mode
Router IP RIM= 1 byte, value of
Address Mode 0 or 1
Command or
Response to
Query
Command or Query.
Used to set the NP card's Bridged Point to Multipoint mode, where:
0 = Off
1 = On
Example: BRT=0
Command or Query.
Used to set the NP Card's Working Mode where:
1 = Vipersat Hub
2 = Vipersat Hub Expansion
3 = Vipersat Remote
4 = Vipersat Remote Expansion
5 = Multipoint Hub
6 = Multipoint Remote
7 = Point to Point
8 = GigaBit Bridge
Example: GBM=7
Command or Query.
Used to set the IP address and network prefix for the
NP Interface Management port, in the form aaa.bbb.ccc.ddd.ee, where:
aaa.bbb.ccc.ddd = IP address, and
ee = network prefix (0-31)
Example: MIP=010.006.030.001.24
Command or Query.
Used to set the modem IP Interface security level where:
0 = Normal or Low Level Security, and
1 = High Level Security
Example: MIS=0
Command or Query.
Used to set the NP Card's IP address mode where:
0 = Single IP Address, and
1 = Dual IP Address
Example: RIM=0
Description of Arguments
C–40
Revision 8
MN-SLM5650A
Query
Response to (Instruction
Response to Query
Command Code and
Qualifier)
BRT= BRT? BRT=a
BRT? (see Description
BRT* of Arguments)
BRT#
GBM= GBM? GBM=a
GBM? (see Description
GBM* of Arguments)
GBM#
MIP= MIP? MIP=aaa.bbb.ccc
MIP? .ddd.ee
MIP* (see Description
MIP# of Arguments)
MIS= MIS? MIS=a
MIS? (see Description
MIS* of Arguments)
MIS#
RIM= RIM? RIM=a
RIM? (see Description
RIM* of Arguments)
RIM#