C.6.1 Initial Setup – Priority Commands / Queries - Comtech EF Data SLM-5650A Installation And Operation Manual

SLM-5650A Satellite Modem
Appendix C
C.6.1 Initial Setup – Priority Commands / Queries
Before executing any Modem, Unit, Bulk/Global, AUPC, or Optional Interface commands/queries, initial setup should be accomplished with these
three commands, prioritized as follows: (Highest Priority) MOM, RFB, ITF (Lowest Priority). Priority commands are indicated by
throughout these sections. Any change to a higher priority parameter can override any of the parameters of lower priority.
Command
Parameter (Instruction
Type Code and
Qualifier)
Modem MOM= 1 hex byte,
Operating value 0 thru C
Mode
Modem RF RFB= 1 byte, value 0
Band or 1
Interface Type ITF= 1 byte, value 0
thru 7
Arguments for
Command or
Response to
Query
Command or Query.
Modem Operating Mode, where:
x = 0=OM-73
1=Mil-165A
2=IESS-308
3=IESS-309
4=IESS-310
5=TURBO
6=16QAM
7=AUPC
8=RXBURST
9=TXBURST
A=TURBO-FA
B=RXBRSTFA
C=LDPC
Example: MOM=0 (sets OM-73 operating mode)
Command or Query.
Modem RF Band, where:
0=70/140 MHz Band
1=L-Band (950 MHz – 2000 MHz)
Example: RFB=0 (sets 70/140 Band)
Command or Query.
Interface Type, where:
0=EIA-530
1=HSSI
2=Unbalance G.703
3=Balanced G.703
4=GigaBit Ethernet Interface
6=Network Processor Card
7=LVDS Interface
Example: ITF=0 (sets EIA-530 interface type)
Description of Arguments
C–7
Revision 8
MN-SLM5650A
shading
Query
Response to (Instruction
Response to Query
Command Code and
Qualifier)
MOM= MOM? MOM=x
MOM? (see Description
MOM* of Arguments)
MOM#
RFB= RFB? RFB =x
RFB? (see Description
RFB * of Arguments)
RFB #
ITF= ITF? ITF=x
ITF? (see Description
ITF* of Arguments)
ITF#