Comtech EF Data SLM-5650A Installation And Operation Manual page 113

SLM-5650A Satellite Modem
Front Panel Operation
CONFIG: IP
SNMP Traps IP Address #X:
Where X indicates IP Address #1 or IP Address #2: To edit the SNMP Trap Destination IP
Address, first use the
keys to edit the value of that digit. Press [ENT] when done.
Note: If both Trap IP Addresses are 000.000.000.000, it means that Trap is disabled.
CONFIG: IP
SNMP Trap Community:
comtech
To edit the SNMP Trap Community string, first use the
character to edit, and then use the arrow keys to edit that character.
Note: Only the first 20 characters on the bottom line are available.
All printable ASCII characters are available with the exception of the backslash '/' (ASCII
code 92) and tilde '~' (ASCII code 126).
Once the string has been composed, press [ENT]. All trailing spaces are removed from the
Trap Community string upon entry.
CONFIG: IP
SNMP Version: SNMPv1
Select SNMPv1 or SNMPv2 using the
CONFIG: Remote
Option Card Addr: Gigabit Ethernet
Select Gigabit Ethernet or Network Proc using the
CONFIG: Remote
Ethernet
Option Card Ethernet IP Address/Range:
EthernetConfig

000.000.000.000
arrow keys to select the digit to edit, and then use the  arrow

EthernetConfig

EthernetConfig

EthernetConfig

EthernetConfig

192.168.001.002/24
SNMP Traps
 
(E)
SNMP Traps
 
(E)

SNMP Traps
 
SNMPv2
arrow keys, and then press [ENT].

Option Card Addr

Network Proc
arrow keys, and then press [ENT].

Option Card Addr

(E)
5–31
MN-SLM5650A
Address #1/#2

Community

arrow keys to select the
Version

(E)
Gigabit

Revision 8