Comtech EF Data SLM-5650A Installation And Operation Manual page 388

SLM-5650A Satellite Modem
Appendix C
Command Arguments for
Parameter (Instruction
Type Code and
Qualifier)
AUPC Remote RCL= 1 byte, values
Carrier Loss of 0 thru 2
Action
Remote Modem RPB= 1 byte, values
Pattern of 0 or 1
Substitution
Remote Modem RPC= 1 byte, values
AUPC Enable of 0 or 1
Remote Modem N/A 6 bytes
BERT BER
Remote Modem RPL= 1 byte, values
I/O Loopback of 0 or 1
Command or
Response to
Query
Command or Query.
Tx Output Power level setting when remote carrier is lost, where:
0=Hold current output power level
1=Goto Nominal output power level
2=Goto Maximum output power level
Example: RCL=0
Command or Query.
Remote Modem Tx Pattern Substitution, where:
0=Off
1=On
Note: For compatibility reasons, only the 2047 Tx pattern can be turned On or Off at
the remote modem.
Example: RPB=1 (Turn on remote modem AUPC Control)
Command or Query.
Remote Modem AUPC Control, where:
0=Off
1=On
Example: RPC=1 (Turn on remote modem AUPC Control)
Query only.
Unit returns the value of the remote modem's BERT BER in the form a.b x 10
three bytes are the value. Last two bytes are the exponent. Returns 0.0E00 if the
BERT is not synchronized to a pattern.
Example: RPE=4.0E06
Command or Query.
Remote Modem I/O Loopback Mode, where:
0=Off
1=On
Example: RPL=1 (Turn on remote modem AUPC Control)
Description of Arguments
C–36
MN-SLM5650A
Query
Response to (Instruction
Command Code and
Qualifier)
RCL= RCL?
RCL?
RCL*
RCL#
RPB= RPB?
RPB?
RPB*
RPB#
RPC= RPC?
RPC?
RPC*
RPC#
N/A RPE?
-c
. First
RPL= RPL?
RPL?
RPL*
RPL#
Revision 8
Response to Query
RCL=x
(see Description
of Arguments)
RPB=x
(see Description
of Arguments)
RPC=x
(see Description
of Arguments)
RPE=a.bEcc
(see Description
of Arguments)
RPL=x
(see Description
of Arguments)