Comtech EF Data SLM-5650A Installation And Operation Manual page 105

SLM-5650A Satellite Modem
Front Panel Operation
Vipersat mode should not be selected from the front panel under most
circumstances. Refer to the supplementary Vipersat User Guide (CEFD P/N MN-
0000035) for detailed information on configuring the Vipersat features.
When selecting an IF frequency band, both transmit and receive operate in the
selected band. Operation of transmit in one IF frequency band and the receive in
the other IF frequency band is not permitted.
When selecting a data interface type, a native interface can be selected even if an
optional interface is installed, but an optional interface can only be selected if it is
installed. Both transmit and receive must use the selected interface type.
Transmitting using one interface type and receiving using another interface type is
not permitted.
5.2.3.4 CONFIG: AUPC
The user must first go to CONFIG: MODE to set the modem type as AUPC in order to
select this menu.
AUPC: Local
Use the  arrow keys to select Local, Remote, ASYNC, or Logging, and then press [ENT].
CONFIG: AUPC
Local AUPC: Enable: Off Power Settings
Target Setting
First, use the arrow keys to select Enable, Power Settings, Target Setting, or Carrier
Loss Action, and then press [ENT].
CONFIG: AUPC
Use the  arrow keys to select to enable AUPC on the local modem as On or Off, and then
press [ENT] when done.
CONFIG: AUPC
Local AUPC Power: Nominal: -10.0 dBm
First, use thearrow keys to select Nominal:, Min:, or Max:, and then press [ENT].
Then, for all selections, use thearrow keys to first select the digit to edit, and then use the
 arrow keys to edit the value of that digit. Press [ENT] once again when done.
Remote
Logging
Local

Carrier Loss Action (E)
Local

Local
 
Min: -30.0 dBm
ASYNC
Enable

Power Settings
Max: -05.0 dBm
5–23
Revision 8
MN-SLM5650A
(E)
(E)