Comtech EF Data SLM-5650A Installation And Operation Manual page 111

SLM-5650A Satellite Modem
Front Panel Operation
CONFIG: Remote
Local M&C Bus Format:
Use the  arrow keys to select the character format 7N1, 7E1, 7O1, 7N2, 7E2, 7O2, 8N1
(default), 8E1, 8O1, 8N2, 8E2, or 8O2, and then press [ENT].
CONFIG: Remote
Local M&C Bus Baud Rate:
Use the  arrow keys to select a Baud Rate of 2400, 4800, 9600, 19200, 38400 (default),
57600, or 115200, and then press [ENT].
CONFIG: Remote
Ethernet Config:
Gateway
Use the arrow keys to select IP Address/Range, MAC, Gateway, SNMP, or Option Card
Addr, and then press [ENT].
Option
IP Address/Range
MAC
Gateway
SNMP
Option Card Addr
CONFIG: Remote
SNMP: Communities
Use the arrow keys to select Communities or Traps, and then press [ENT].
SerialConfig

SerialConfig

38400 Baud
EthernetConfig

IP Address/Range
SNMP Option Card Addr
Function
Select the IP Address.
Displays the modem's MAC Address: This is programmed at the factory and is not user
changeable. If installed, the Gigabit Ethernet Interface's MAC Address will also be
displayed.
The IP Gateway Address is the default address that the modem will send all IP responses
when the message originated from a source outside the modems local attached network.
Select and control Communities or Traps. Detailed information follows.
Select to set the optional Gigabit Ethernet or Network Processor Module's Ethernet
interface IP Address and subnet mask (range). When Network Proc is selected, module
configuration options are also available. (Detailed information for configuring either option
card follows.)
EthernetConfig

Traps
5–29
Format

8N1
Baudrate

MAC
(E)
SNMP

(E)
Revision 8
MN-SLM5650A
(E)
(E)