Acm Configuration And Operation Using Serial Remote Control Commands/Queries - Comtech EF Data CDM-760 Installation And Operation Manual

Appendix G
CDM-760 Advanced High-Speed Trunking Modem
G.5.4.2 ACM Configuration and Operation Using Serial Remote Control
Commands/Queries
The operands available through the CDM-760 Serial Interface are identified in the following table –
details on using these remote commands and queries are explicitly defined in Chapter 8.
Operand Description
ACM Sets or reports ACM operating parameters.
ADC Sets or reports ACM degradation-on-configuration parameters.
RES Reports the value of the remote demod Es/No, in dB.
LES Reports the value of the local Es/No, in dB.
TMC Sets or reports Tx modulation (TMC=00 is ACM mode)
RMC Sets or reports Rx demodulation (RMC=00 is ACM mode)
Reports the global modem configuration, including ACM Operating Parameters and ACM
MGC
Degradation Configuration
EID Reports the equipment ID and installed options, including ACM
G–30
Revision 4
MN-CDM760