Figure 8-21. Lan | Ethernet Ports Page - Comtech EF Data SLM-5650A Installation And Operation Manual

SLM-5650A Satellite Modem
Network Processor (NP) Interface
With Proxy ARP enabled, the NP Interface (in Router Mode) 'snoops' all ARP_REQs; it will
send an ARP_REPLY (one if the ARP_REQ host address is an NP host address that is reachable
via one of the routes in the Route Table).
Using the drop-down menu, set Proxy ARP Enable as Enabled or Disabled. Then, click
Submit] to save the desired Proxy ARP Enable setting.
8.6.6.4.2 LAN | Ethernet Ports
Use this page to view the current status of the Ethernet ports and to set each port to manual or
auto-negotiate configuration. Only the NP Interface Ethernet ports are shown in this screen. The
base modem Ethernet port statistics and port information are set from the modem's front panel.
Ethernet Link Status
This read-only section displays the status for each NP Interface Ethernet port.
Ethernet Speed/Duplex
Use the drop-down menus to configure each port to one of the following states:
Auto
Click [Submit] once the Ethernet ports have been configured to suit on this page.

Figure 8-21. LAN | Ethernet Ports page

1000 Full 100 Full
8–35
10 Full 100 Half
Revision 8
MN-SLM5650A
10 Half