Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
console(config-if-Gi1/0/2)#sflow 1 polling 6055
sflow sampling
Use the sflow sampling command to enable a new sflow sampler instance for
this data source if rcvr_idx is valid. An sflow sampler collects flow samples to
send to the receiver. Use the "no" form of this command to reset sampler
parameters to the default.
Syntax
rcvr-index
sflow
sampling {gigabitethernet | tengigabitethernet |
fortygigabitethernet}
rcvr-index
no sflow
fortygigabitethernet}
rcvr-index — The sFlow Receiver for this sFlow sampler to which flow
•
samples are to be sent. If no receiver is configured, then no packets will be
sampled. Only active receivers can be set. If a receiver times out, then all
samplers associated with the receiver will also expire. (Range: 1–8).
interface-list — The list of interfaces to poll in unit/slot/port format.
•
sampling-rate — The statistical sampling rate for packet sampling from this
•
source. A value of n means that out of n incoming packets, 1 packet will be
sampled. (Range: 1024–65536).
size —The maximum number of bytes that should be copied from the
•
sampler packet (Range: 20–256 bytes).
Default Configuration
There are no samplers configured by default.
The default is no default sampling rate.
interface-list sampling-rate
sampling {gigabitethernet | tengigabitethernet |
interface-list
size
[
]
Sflow Commands
1601