Structural Floor - Autodesk 256B1-05A761-1301 - AutoCAD Revit Structure Suite 2010 User Manual

Name
Identity Data
Comments
Mark
Phasing
Phase Created
Phase Demolished
Structural Analysis
Analyze As

Structural Floor

You can add a structural floor to the building model. It uses a similar interface and functionality as creating
floors. This functionality includes creating and editing slab edges, thickened slabs, drop panels, or ramps,
as well as user selection and user creation of structural floor types.
Description
This parameter is affected by the family parameter Cap (see
and Parameters on page 433). The following image shows the difference between
the Cap parameter enabled (in red) and disabled (in green).
The Elevation at Bottom measurement is taken from this setting.
This is a read-only parameter.
A field for entering comments about the wall.
A label created for the element. This value must be unique for each element in
a project. Revit Architecture warns you if the number is already used but allows
you to continue using it. You can see the warning using the Review Warnings
tool. See Reviewing Warning Messages
Indicates in which phase the component was created. See
page 1331.
Indicates in which phase the component was demolished. See
on page 1331.
Indicates the property type for structural analysis. Select either Foundation or
Not for Analysis.
Family Category
on page 1415.
Project Phasing
Project Phasing
Structural Floor | 929
on