Step 11: Connect The Switching Plane Cables To The Tx Matrix Plus Router; Step 12: Integrate The Line-Card Chassis Into The Routing Matrix; Tx Matrix Plus Safety Warnings - Juniper TX Matrix Plus Quick Start Manual

Hide thumbs Also See for TX Matrix Plus:

Table of Contents

Step 11: Connect the Switching Plane Cables to the TX Matrix Plus Router

See the TX Matrix Plus Router Hardware Guide for information about labeling and

connecting acitve optical cable (AOC) cables, CXP cables, or fiber-optic array cables.

For instructions on integrating the line-card chassis (LCC) into the routing matrix, see

the TX Matrix Plus Router Hardware Guide.

WARNING:

See installation instructions before connecting the router. This

is a summary of safety warnings. For a complete list of warnings for this

router, including translations, see the TX Matrix Plus Router Hardware Guide.

WARNING:

The intrabuilding port(s) of the router is suitable for connection

to intrabuilding or unexposed wiring or cabling only. The intrabuilding port(s)

of the router MUST NOT be metallically connected to interfaces that connect

to the OSP or its wiring. These interfaces are designed for use as intrabuilding

interfaces only (Type 2 or Type 4 ports as described in GR-1089-CORE, Issue

4) and require isolation from the exposed OSP cabling. The addition of primary

protectors is not sufficient protection to connect these interfaces metallically

to OSP wiring.

CAUTION:

Before removing or installing components of a router, attach an

ESD strap to an ESD point and place the other end of the strap around your

bare wrist. Failure to use an ESD strap could result in damage to the router.

Only trained and qualified personnel should install or replace the router.

Perform only the procedures described in this Quick Start or the TX Matrix Plus Router

Hardware Guide. Other services should be performed by authorized service personnel

only.

Read the installation instructions before you connect the router to a power source.

Before installing the router, read the guidelines for site preparation in the TX Matrix

Plus Router Hardware Guide to make sure that the site meets power, environmental,

and clearance requirements for the router.

When installing the router, do not use a ramp inclined more than 10 degrees.

Installing the router requires at least four people.

Step 11: Connect the Switching Plane Cables to the TX Matrix Plus Router

Table of Contents