Replacing A Dimm Module In A T4000 Re-C1800 Routing Engine; Removing A Dimm Module From A T4000 Re-C1800 Routing Engine; Installing A Dimm Module Into A T4000 Re-C1800 Routing Engine - Juniper T4000 Hardware Manual

T4000 Router Hardware Guide
Related
Documentation

Replacing a DIMM Module in a T4000 RE-C1800 Routing Engine

Removing a DIMM Module from a T4000 RE-C1800 Routing Engine

Installing a DIMM Module into a T4000 RE-C1800 Routing Engine

276
Reboot the router's software again. Issue the
7.
Verify that the SSD is listed as the secondary boot device. The output lists the devices
8.
mounted. The SSD is located at
T4000 Routing Engine Description on page 39
T4000 RE-C1800 Routing Engine Description on page 40
T4000 RE-C1800 LEDs on page 41
T4000 Craft Interface LEDs on page 25
Preventing T4000 Electrostatic Discharge Damage on page 296
Chassis Operational Mode Commands
System Software Operational Mode Commands
Removing a DIMM Module from a T4000 RE-C1800 Routing Engine on page 276
1.
Installing a DIMM Module into a T4000 RE-C1800 Routing Engine on page 276
2.
To remove a DIMM module:
Place an electrostatic bag or antistatic mat on a flat, stable surface.
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis.
Remove the Routing Engine. See
3.
Eject the DIMM module by pressing the plastic ejectors on both sides of the DIMM
4.
module.
Grasp the DIMM module, being careful not to touch any electrical components on the
5.
module, and firmly pull it out of the slot on the Routing Engine.
Place the DIMM module on the antistatic mat or in the electrostatic bag.
6.
Push the plastic ejectors to close the empty DIMM module slot.
7.
To insert a DIMM module into the Routing Engine:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Remove the DIMM module from its electrostatic bag.
2.
To open the empty DIMM slot, press the plastic ejectors open.
3.
request system reboot
ad1 . Issue the show system boot-messages
"Replacing a T4000 Routing Engine" on page
Copyright © 2013, Juniper Networks, Inc.
command.
command.
267.