Reinstalling The T320 Scgs; Figure 52: Reinstalling The Rear T320 Fan Tray - Juniper Core Router T Series Hardware Manual
Hide thumbs
Also See for Core Router T Series:
- Monitoring and troubleshooting manual (812 pages) ,
- Handling instructions manual (12 pages)
Table of Contents
Advertisement
See Also
Reinstalling the T320 SCGs
Copyright © 2018, Juniper Networks, Inc.
Figure 52: Reinstalling the Rear T320 Fan Tray
To reinstall the SCGs (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Carefully align the sides of the SCG with the guides in the SCG slot.
2.
Grasp the SCG by its handle and slide it straight into the chassis until it contacts the
3.
midplane.
Tighten the captive screws on the corners of the SCG faceplate.
4.
Repeat the procedure to reinstall the remaining SCG.
5.
Chapter 18: Installing the T320 Without a Mechanical Lift
Figure 53 on page
144):
143
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Core Router T Series and is the answer not in the manual?
Questions and answers