Removing The T320 Rear Fan Tray; Figure 47: Removing A T320 Scg - Juniper Core Router T Series Hardware Manual
Hide thumbs
Also See for Core Router T Series:
- Monitoring and troubleshooting manual (812 pages) ,
- Handling instructions manual (12 pages)
Table of Contents
Advertisement
See Also
Removing the T320 Rear Fan Tray
Copyright © 2018, Juniper Networks, Inc.
Press the online/offline button on the SCG faceplate and hold it down until the LED
3.
goes out (about 5 seconds).
Loosen the captive screws on the edges of the SCG faceplate.
4.
Grasp the SCG by the handle on the faceplate and slide it out of the chassis.
5.
Place the SCG on the antistatic mat.
6.
Repeat the procedure for the second SCG.
7.
Figure 47: Removing a T320 SCG
Preventing Electrostatic Discharge Damage to a T320 Router on page 330
T320 SONET Clock Generator (SCG) Description on page 19
The rear fan tray is mounted vertically on the right side of the rear of the chassis. The rear
fan tray contains five fans. The fan tray weighs about 7.3 lb (3.3 kg).
Chapter 18: Installing the T320 Without a Mechanical Lift
135
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Core Router T Series and is the answer not in the manual?