Step 3: Install The Router; Install The Router Using A Mechanical Lift; Install The Installation Handle; Install The Router Using A Lift - Juniper M320 Quick Start Manual

M320 Multiservice Edge Router Quick Start

Step 3: Install the Router

Install the Router Using a Mechanical Lift

12
To install the router:
Install the Router Using a Mechanical Lift on page 12
Install the Router Without a Mechanical Lift on page 13
Install the Installation Handle on page 12
Install the Router Using a Lift on page 12

Install the Installation Handle

Remove the three lowest power supplies from the router.
1.
Insert the captive screws of the installation handle into the holes previously occupied
2.
by the captive screws of the lowest three power supplies

Install the Router Using a Lift

WARNING: Do not lift the router using the installation handle or the handles
on top of the chassis. Use these handles only to help position the router.
Make sure the rack is properly secured to the building in its permanent location.
1.
Load the router onto the lift, making sure it rests securely on the lift platform.
2.
Using the lift, position the router in front of the rack or cabinet, centering it in front of
3.
the large mounting shelf.
Carefully lower the router onto the shelf. The shelf ensures that the holes in the
4.
mounting brackets align with the holes in the rack rails.
With one person pulling on the installation handle from the back of the rack or cabinet
5.
while another person pushes on the front-mounting flanges:
Front-mounting in a four-post rack or cabinet: Slide the chassis onto the mounting
shelves until the front-mounting flanges contact the spacer bars.
Center-mounting in a four-post rack or cabinet: Slide the chassis onto the mounting
shelves until the center-mounting brackets contact the rack rails.
Front-mounting in an open-frame rack: Slide the chassis onto the large mounting
shelf until the front-mounting flanges contact the rack rails.
Center-mounting in an open-frame rack: Slide the chassis onto the large mounting
shelf until the center-mounting brackets contact the rack rails.
Move the lift away from the rack.
6.
Install the mounting screws:
7.
Copyright © 2016, Juniper Networks, Inc.