Table of Contents
Advertisement
Attaching the TX Matrix Installation Handle
Copyright © 2010, Juniper Networks, Inc.
Figure 43: Removing a Power Supply Before Installing the Installation
Handle
The installation handles helps you install the TX Matrix router. You attach the installation
handle over the power supply slots of the chassis. To attach the handle:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Insert the captive screws of the handle into the holes previously occupied by the
2.
captive screws of the power supplies (see Figure 44 on page 87).
Tighten the screws, using a Phillips (+) screwdriver, number 2.
3.
Figure 44: Attaching the Installation Handle
Chapter 9: Installing the TX Matrix Chassis Using a Mechanical Lift
87
Advertisement
Table of Contents
Troubleshooting
Subscribe to Our Youtube Channel
Related Manuals for Juniper TX MATRIX
Related Products for Juniper TX MATRIX
- Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 - ADAPTIVE LOG EXPORTER REV1
- Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 - MANAGING VULNERABILITY ASSESSMENT V1
- Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 R2 - INSTALLATION REV1
- Juniper SECURITY THREAT RESPONSE MANAGER - APPLICATION CONFIGURATION GUIDE REV 1
- Juniper SECURITY THREAT RESPONSE MANAGER - SOFTWARE INSTALLATION REV 1
- Juniper TePM Agent
- Juniper TCX1000
- Juniper 6rd
Need help?
Do you have a question about the TX MATRIX and is the answer not in the manual?
Questions and answers