Using Default Report Templates - Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 R2 - REV1 Manual

Table of Contents

Advertisement

216
M
R
ANAGING
EPORTS
Using Default
Report Templates
Step 1
Table 9-13 Available Graph Types (continued)
Pie Graph
Available with the following chart type:
Time Series
TopN Time Series
Note: A report designed with content displayed in a table is available only with a
full page width container.
STRM provides a series of default templates that allows you to manipulate and
customize your data. Default templates are designed for both executive level and
operational level reports.
You can generate a report from any template located in the Report Templates
panel. These templates are also found in the folders within the Report Templates
navigation menu. Templates that do not specify an interval schedule must be
manually generated; others are configured to automatically generate.
Note: By default, report titles that appears with each template has the same name
in the Generated Reports panel. When you re-configure a template and enter a
new report title, your template takes on the new name; however, the original
template remains the same.
Each template is designed to capture and display your existing data. Point your
mouse to any template to preview the summary. The summary reveals how the
template is configured and the type of information the template is configured to
generate.
Note: The STRM application is configured with the timezone used during the
installation and setup of the application. Please check with your administrator to
ensure your STRM session is synchronized with your timezone.
To customize a template:
Click the Reports tab.
The Reports interface appears.
STRM Users Guide
Table Graph
Available with the following charts:
Time Series
Top Attackers
Top Offenses
Top Targeted Assets
TopN Time Series

Advertisement

Table of Contents
loading

This manual is also suitable for:

Security threat response manager 2008.2 r2

Table of Contents