Changing The Port Mode; Table 22: Supported Add Device Workflows By Device Family - Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1 Administration Manual

Supported Add Device Workflows by Device Family
Copyright © 2010, Juniper Networks, Inc.

Changing the Port Mode

After you have added a device, you cannot change the port mode setting using NSM. You
must delete the device from the management system, change the port mode using the
WebUI or CLI, and then add the device again using the Add Device or Add Many Devices
wizard.
When changing the port mode on the device, be aware that:
Changing the port mode removes any existing configurations on the security device
and requires a system reset.
Issuing the unset all CLI command does not affect the port mode setting on the security
device.
Table 22 on page 111 summarizes the methods or workflows you can use to add devices
from each supported device family.

Table 22: Supported Add Device Workflows by Device Family

Device Family (Operating System name)
Add
Device
Workflow ScreenOS IDP
Device is yes yes
reachable
Device is yes yes
not
reachable
Model yes yes
and
activate
device
Rapid yes no
deployment
(configlets)
Device no no
discovery
J Series
and SRX
Secure Infranet Series
Access Controller devices
(SA) (IC) (Junos)
yes yes yes
yes yes yes
no no yes
no no no
no no yes
Chapter 4: Adding Devices
M Series
EX and MX
Series Series
devices devices
(Junos) (Junos)
yes yes
yes yes
yes yes
no no
yes yes
111