Configuring The Ip Phone 2007 - Nortel 1110 Fundamentals

186 Nortel IP Phone 2007
Configuring the IP Phone 2007
Procedure 34
Configuring the IP Phone 2007
Step
1
2
3
4
5
Copyright © 2003–2007, Nortel Networks
.
Action
Configure a virtual loop on the system using LD 97.
For more information about configuring a virtual loop, see IP
Line Fundamentals (NN43100-500) and Software Input Output
Administration (NN43001-611).
Configure the IP Phone 2007 on the system using LD 11. At the
prompt, enter the following:
REQ:chg
TYPE:2007
To configure the IP Phone 2007 using LD 11, see Software Input
Output Administration (NN43001-611).
Connect the IP Phone 2007 components:
a. Connect one end of the handset cord to the handset jack on the
back of the IP Phone (identified with a handset icon).
b. Connect the other end of the handset cord to the handset.
Choose one of the following connections:
• For an IP Phone not sharing a LAN access with a PC:
Connect one end of the CAT5 Ethernet cable to the LAN Ethernet
port located on the back of the IP Phone (identified with a LAN
icon). Plug the other end of the CAT5 Ethernet cable into the
IP network.
• For an IP Phone sharing a LAN access with a PC (identified
with a PC icon):
Connect one end of the CAT5 Ethernet cable to the LAN Ethernet
port located on the back of the IP Phone and the other end to the
IP network. Insert one end of a second CAT5 Ethernet cable into
the PC Ethernet port located on the back of the IP Phone and
the other end into the computer Ethernet port.
Secure the IP Phone footstand to the base of the IP Phone. Use
the angle adjustment grip on the top back of the IP Phone to adjust
the position.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007