Full Duplex Mode - Nortel 1110 Fundamentals

164 Nortel IP Audio Conference Phone 2033
6
7
8

Full Duplex mode

In the Configuration menu, autonegotiate mode is the default setting for
initial startup. Nortel recommends that autonegotiate mode is used on the
network and the IP Phone. Use Full Duplex mode only when the network
is forced Full Duplex for 100BT Full Duplex mode; otherwise, a duplex
mismatch results. No intervention is required under normal operation.
Changing the speed and changing the duplex mode on the phone changes
both the LAN Ethernet port and PC Ethernet Port interfaces.
Copyright © 2003–2007, Nortel Networks
.
Enter the following information:
Screen prompt
Password
Node
TN
Select the Shift soft key labeled (>>) and press Clear to edit the
TN field. The IP Audio Conference Phone 2033 by default places
you in the units field of the TN. You can not use backspace to move
to the loop, shelf or card fields.
The IP Audio Conference Phone 2033 registers with the TPS and, if
needed, begins the firmware download. This takes several minutes.
When the download is complete, the IP Audio Conference Phone
2033 resets.
The current system date and time appear on the top line of the
display when the configuration is complete. Self-labeling keys also
appear.
Check for a dial tone and the correct DN above the display.
(Optional) Customize the soft keys as required. For more information,
see Software Input Output Administration (NN43001-611) and IP
Phone Audio Conference Phone 2033 User Guide (NN43111-100).
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
Description
IP Phone Installer Password.
You are not prompted to enter the IP
Phone Installer Password if it has not been
configured in your system.
The node ID.
The TN or VTN.
—End—