Nortel 1110 Fundamentals page 400

400 Nortel IP Phone 1150E
6
7
8
9
Copyright © 2003–2007, Nortel Networks
.
CAUTION
Damage to Equipment
Do not plug any device into your IP Phone 1150E Ethernet
port other than a PC. The IP Phone 1150E does not
support multiple devices connected through the PC
Ethernet port.
Connect additional cables. If applicable, plug in optional USB
devices. Connect the Ethernet cable to the LAN Ethernet connection.
If you are using an AC power adapter, plug the adapter into an
AC outlet.
Complete steps 1 to 6, as needed, before wall-mounting the IP
Phone.
Wall-mount your phone (optional). Use Method A or Method B to
wall-mount the IP Phone. See Method A—using the mounting
holes on the bottom of the phone stand, or Method B—using the
traditional-style wall-mount box with a CAT5 connector and a 15 cm
(6 inch) CAT5 cord (not provided).
• Method A: Press the wall-mount lever, and pull away from the
stand. Using the stand cover (see
stand cover" (page
the bottom of the stand cover firmly against the wall in the
location where you wish to install the phone. Four small pins on
the bottom of the stand cover make the marks on the wall. Use
the marks as a guideline to install the wall-mount screws (not
provided). See Figure 49 "Cable routing tracks" (page
Install the screws so that they protrude 3 mm (1/8 inch) from the
wall, and then install the phone stand mounting holes over the
screw heads. You may need to remove the phone from the wall
to adjust the lower screws. When the lower screws are snug,
install the phone on the mounting screws, and then tighten the
top screws.
• Method B: Attach the 15 cm (6 inch) CAT5 cable, position the
stand over the mounting rivets, and slide the phone down the
wall so that the rivets fit into the slots on the stand. See
49 "Cable routing tracks" (page
Replace the stand cover. Ensure that all cables are neatly routed
and press the stand cover into place until you hear a click.
If you wall-mount the phone, put it in the wall-mount position by
holding the tilt lever and press the phone towards the base until the
phone is parallel with the base. Release the tilt lever and continue
to push the phone towards the base until you hear a click. Ensure
the phone is securely locked in to position.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
Procedure 80 "Remove the
396)), mark the wall-mount holes by pressing
399).
399).
Figure