Nortel 1110 Fundamentals page 121

8
9
10
Timing information
There are only four seconds between plugging in the IP Phone 2004 power
transformer and the appearance of the Nortel logo in the middle of the display.
When you see the logo, you have 1 second to respond by pressing the four soft
keys at the bottom of the display in sequence from left to right, one at a time. If
you miss the 1-second response time, the IP Phone 2004 attempts to locate
the connect server. You can begin the power-up sequence again, or you can
double-press the Services key to open the network diagnostic utilities to access
the IP Phone settings. See
To edit network configuration, the following soft keys are available:
•
•
•
•
Copyright © 2003–2007, Nortel Networks
.
For information about the IP Phone firmware upgrade using Element
Manager, see Element Manager System Reference—Administration
(NN43001-632).
The IP Phone 2004 can support primary (S1) and secondary (S2)
connect server. If you require IP Phones to register on multiple
nodes, see IP Line Fundamentals (NN43100-500).
The IP Phone 2004 searches for the connect server.
Enter the following information
The IP Phone 2004 registers with the TPS and, if needed, begins the
firmware download. This takes several minutes. When registration is
complete, the IP Phone 2004 resets.
The current Call Server date and time appear on the top line of the
display when the configuration is complete. Self-labeling keys also
appear.
Check for a dial tone and the correct DN above the display.
(Optional) Customize the feature keys as required. For more
information, see IP Phone 2004 User Guide (NN43117-102).
OK—accept current settings and proceed to the next configuration
option. If all configuration options are presented, the configuration is
saved and the IP Phone reboots with the saved changes.
BkSpace—erase a configuration entry to change it
Clear—clear an entire configuration entry
Cancel—cancels network configuration. The IP Phone reboots without
saving changes.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
Installation and configuration 121
—End—
ATTENTION
Appendix "IP Phone diagnostic utilities" (page 469).