First-Time Installation; Configuring The Ip Phone 1120E - Nortel 1110 Fundamentals

318 Nortel IP Phone 1120E

First-time installation

You must first install an IP telephony node with the Communication Server.
For information about installing an IP telephony node, see Signaling Server
Installation and Commissioning (NN43001-312) or IP Line Fundamentals
(NN43100-500).
Configuring the IP Phone 1120E
You must configure the IP Phone 1120E before you can use it. Use
Procedure 65 "Configuring the IP Phone 1120E" (page 318)
IP Phone 1120E for the first time.
Procedure 65
Configuring the IP Phone 1120E
Step
1
2
Copyright © 2003–2007, Nortel Networks
.
CAUTION
Do not plug your IP Phone 1120E into an ISDN connection.
Severe damage can result. The IP Phone 1120E does not support
multiple devices connected through the PC Ethernet port.
Action
Configure a virtual loop on the Call Server using LD 97.
For more information about configuring a virtual loop, see IP
Line Fundamentals (NN43100-500), and Software Input Output
Administration (NN43001-611).
Configure the IP Phone 1120E on the Call Server using LD 11. At
the prompt, enter the following
REQ:chg
TYPE: 1120
For more information about configuring the IP Phone 1120E using
LD 11, see Software Input Output Administration (NN43001-611).
CAUTION
The IP Phone 1120E is shipped with the stand locked
in position. To avoid damaging the IP Phone, press the
wall-mount lever located under the Handsfree key to
release the stand and pull it away from the phone. See
Figure 33 "Release the IP Phone 1120E from the stand"
(page 319)
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
to configure the