Nortel 1110 Fundamentals page 149

4
5
Copyright © 2003–2007, Nortel Networks
.
Connect the CAT5 Ethernet cable attached to the PoE module to the
IP Phone. Thread the CAT5 Ethernet cable through the channel on
the bottom of the IP Phone and plug it into the PoE module port on
the IP Phone.
Connect the AC power adapter (optional) to the power supply port
located on the back of the PoE module, Leave the AC power adapter
unplugged from the power outlet. Thread the cord through the
channel on the bottom of the PoE module then plug the other end
into the AC power source. Ensure you use the correct AC power
transformer. The voltage rating of the transformer must match the
wall outlet voltage. See
CALA, AP, and GC" (page 144)
EMEA" (page 145).
Figure 14 "POE module" (page 149)
(PoE) module.
Figure 14
POE module
Red LEDs on the IP Audio Conference Phone 2033 indicate power.
Messages indicating system start up, such as Loading, Initializing
network, and Loading boot parameters appear after a short delay.
Figure 15 "Bottom view of IP Audio Conference Phone 2033" (page
150) shows the bottom view of the IP Audio Conference Phone 2033.
The IP Audio Conference Phone 2033 supports both AC power and
Power over LAN options, including IEEE 802.3af Power Classification
0. To use Power over Ethernet, where power is delivered over the
CAT5 cable, the LAN must support Power over Ethernet, and an
AC adapter is not required. To use local AC power, the optional AC
adapter can be ordered separately.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
Installation and configuration 149
Table 16 "Components list for US, CA,
or Table 17 "Components list for
shows the Power over Ethernet