334 Nortel IP Phone 1120E
8
When the IP Phone 1120E restarts, the firmware reads the setting for Full
Duplex mode and sets both port 0, network interface port, and port 1, PC
interface port, accordingly.
Use
activation of Full Duplex mode.
Procedure 69
Checking Ethernet Statistics
Step
1
2
TFTP firmware upgrade
When you enter Cfg TFTP = 1 (for yes), and enter an IP address, the IP
Phone searches for an upgrade file on the TFTP Server.
Users of CS 1000 Release 4.5, or later do not need to enter a TFTP IP
address.
For further information about TFTP firmware upgrade, see
Server" (page
Copyright © 2003–2007, Nortel Networks
.
Press the Apply&Reset soft key to save the changes and to restart
the IP Phone 1120E.
Procedure 69 "Checking Ethernet Statistics" (page 334)
Action
Double-press the Services key.
Press 2 to select Local Diagnostics, then press 3 to open the
Ethernet Statistics menu.
If Full Duplex mode is active, the following is displayed
•
Link Status: UP
•
Duplex Mode: Full
•
Network Speed: 10 MB, 100 MB, or 1 G
•
Auto Sense/Negotiate
— Auto-Negotiate Capability: No
— Auto-Negotiate Completed: No
533).
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
—End—
—End—
to confirm
Appendix "TFTP