Replacing An Ip Phone 1150E - Nortel 1110 Fundamentals

414 Nortel IP Phone 1150E
3
4
5
6

Replacing an IP Phone 1150E

Two IP Phones cannot share the same TN. You must remove the IP Phone 1150E
that currently uses the TN.
Procedure 85
Replacing an IP Phone 1150E
Step
1
2
3
4
Copyright © 2003–2007, Nortel Networks
.
b. Set the password as non-NULL.
Press OK when the node number displays.
If
the node password is enabled and
is not NULL
the node password is disabled
Enter the password at the password screen, and press OK.
A TN screen displays.
To obtain the password, enter the nodePwdShow command in
Element Manager. For further information, see Element Manager
System Reference—Administration (NN43001-632).
Select the Clear soft key to clear the existing TN.
Enter the new TN.
Action
Obtain the node and TN information of the phone you want to
replace.
Disconnect the IP Phone 1150E that you want to replace.
Follow Procedure 80 "Configuring an IP Phone 1150E" (page 395)
to install and configure the IP Phone 1150E.
Enter the same TN and Node Number as the IP Phone 1150E you
replaced. The system associates the new IP Phone 1150E with
the existing TN.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
Then
a password screen displays. Go
to Step 4.
a TN screen displays. Go to
5.
—End—
ATTENTION
Step