Nortel 1110 Fundamentals page 324

324 Nortel IP Phone 1120E
2
3
4
5
6
7
Copyright © 2003–2007, Nortel Networks
.
sequence from left to right. The 3. Network Configuration menu
opens.
You can press the Apply&Reset soft key to save the following
settings and to reset the IP Phone. You can press the Exit soft key
exit the menu to exit the menu without saving any changes and
return to the 3. Network Configuration menu.
When the 3. Network Configuration menu opens, the Enable
802.1x (EAP) check box is highlighted.
Press the Enter key to switch this item on and off. A check mark
appears to indicate the item is active.
If 802.1x Authentication is enabled, press the Enter key to start the
edit mode. Use the keypad to fill in the following information
• Device ID
•
Password
• Retype password
For further information about EAP, see
network access control" (page
If you do not enable 802.1x Authentication, you are not prompted to
enter Device ID and Password.
Use the Right navigation key to scroll and highlight Enable 802.1x
(LLDP Enable) check box. Press the Enter key to switch this item
on and off.
For information about LLDP, see
Discovery Protocol" (page
Use the Right navigation key to scroll and highlight DHCP list.
Press the Enter key.
Press the Down navigation key to open list box.
Use the Up/Down navigation keys to scroll and highlight one of the
following DHCP options
• No—disable DHCP support and enter IP network information
manually.
• Partial—IP network information (IP address, network mask, and
gateway address) are provided by the DHCP server. Enter
Server 1 IP address, Server 2 IP address, Port, Action, Retry,
and PK numbers manually.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
Appendix "802.1x Port-based
455).
Appendix "802.1ab Link Layer
457).