Nortel 1110 Fundamentals page 189

Parameter
Connect Server (IP address, port,
action and retry count—primary and
secondary)
User ID (Node ID, Node Password
and TN)
Installing the IP Phone 2007
To install the IP Phone 2007, use
2007" (page
Timing information
There are only four second(s) between plugging in the IP Phone 2007 power
adapter and the appearance of Nortel on the display. When Nortel appears in
the middle of the screen, you have 1 second to respond by pressing 0, 0, 7, *.
If you miss the 1-second response time, the IP Phone 2007 attempts to locate
the connect server. You can begin the power-up sequence again, or you can
double-press the Services key to open the network diagnostic utilities to access
the IP Phone settings. See
You can press the Apply&Reset soft key at any time to apply the current
configuration and reset the phone. You can press the Exit soft key to
exit the menu without saving any changes and return to the Network
Configuration menu.
When the Network Configuration menu opens, Enable 802.1x Auth. (EAP)
is the first option in the list.
Procedure 35
Installing the IP Phone 2007
Step
1
2
3
4
Copyright © 2003–2007, Nortel Networks
.
Method of Acquisition
Manually entered or automatically retrieved through Full
DHCP.
Manually entered for first-time configuration. Retrieved
from local storage on subsequent power cycles.
189).
Appendix "IP Phone diagnostic utilities" (page
Action
Use the Right navigation key to scroll and highlight the Enable
802.1x Auth. (EAP): list box.
Press the Down navigation key to open list box.
Use the Up/Down navigation keys to scroll and highlight Yes to
enable 802.1x Authentication, or No to disable 802.1x Authentication.
If 802.1x Authentication is enabled, use the dialpad to fill in the
following information:
• Device ID
• Password
• Retype the password
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
Installation and configuration 189
Procedure 35 "Installing the IP Phone
ATTENTION
469).