Nortel 1110 Fundamentals page 115

5
6
7
Copyright © 2003–2007, Nortel Networks
.
For more information about LLDP, see
Discovery Protocol" (page
see Appendix "802.1Q VLAN description" (page
At the prompt DHCP Yes/No?, enter 0-N (0 for No).
By default, Full DHCP is configured on the IP Phone 2004.
Depending on the configuration requirements, you can change
the IP Phone 2004 configuration to allow the following IP address
assignments:
• Static—enter all parameters
• Partial DHCP—IP Phone address, subnet mask, and default
Gateway are obtained from the DHCP server
• Full DHCP— (default) all parameters are obtained from the
DHCP server
A DHCP server and DHCP relay agents must also be installed,
configured, and running if you choose Partial DHCP, or Full DHCP
configuration. For more information about how to set up DHCP
servers for use with the IP Phones, see Converging the Data
Network with VoIP Fundamentals (NN43001-260).
Enter the following information:
Screen prompt
set IP
net msk
def gw
Enter the information for the primary Connect Server (S1) and the
secondary Connect Server (S2):
Screen prompt
S1 IP
S1 Port
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
Installation and configuration 115
Appendix "802.1ab Link Layer
457). For more information about 802.1Q,
Description
a valid IP Phone 2004 IP address.
a subnet mask.
the default Gateway for the IP Phone 2004
on the LAN segment to which it connects.
Description
The primary CS 1000 node IP
address for the IP Phone 2004.
This is a fixed value: 4100
447).