Nortel 1110 Fundamentals page 44

44 Nortel IP Phone 2001
Installing the IP Phone 2001
To install the IP Phone 2001 for the first time using manual configuration,
use
manual configuration" (page
time using DHCP, use
first time using DHCP" (page
Timing information
There are only four seconds between plugging in the IP Phone 2001 power
transformer and the appearance of the Nortel logo in the middle of the display.
When you see the logo, you have 1 second to respond by pressing the four soft
keys at the bottom of the display in sequence from left to right, one at a time. If
you miss the 1-second response time, the IP Phone 2001 attempts to locate
the connect server. You can begin the power-up sequence again, or you can
double-press the Services key to open the network diagnostic utilities to access
the IP Phone settings. See
To edit network configuration, the following soft keys are available:
•
•
•
•
Procedure 2
Installing the IP Phone 2001 for the first time using manual configuration
Step
1
2
3
Copyright © 2003–2007, Nortel Networks
.
Procedure 2 "Installing the IP Phone 2001 for the first time using
Procedure 3 "Installing an IP Phone 2001 for the
OK—accept current settings and proceed to the next configuration
option. If all configuration options are presented, the configuration is
saved and the IP Phone reboots with the saved changes.
BkSpace—erase a configuration entry to change it
Clear—clear an entire configuration entry
Cancel—cancels network configuration. The IP Phone reboots without
saving changes.
Action
When the Nortel logo appears in the middle of the display,
immediately press the four soft keys at the bottom of the display in
sequence from left to right.
At the prompt EAP Enable?, enter 1-Yes (1 for Yes) if the network
infrastructure supports 802.1x port-based network access control.
Enter DeviceID and Password.
If you select 0-No (0 for No), you are not prompted to enter Device
ID and Password.
For more information about EAP, see
network access control" (page
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
44). To install the IP Phone 2001 for the first
51).
ATTENTION
Appendix "IP Phone diagnostic utilities" (page
Appendix "802.1x Port-based
455).
469).