Nortel 1110 Fundamentals page 325

8
9
10
11
12
13
14
Copyright © 2003–2007, Nortel Networks
.
•
Full—IP network information, Server 1 IP address, Server 2 IP
address, and XAS information are provided by the DHCP server.
All items are dimmed to prevent manual entry.
A DHCP server and DHCP relay agents must also be installed,
configured, and running if you choose Partial DHCP, or Full DHCP
configuration.
For more information about how to set up DHCP servers for use
with the IP Phones, see Converging the Data Network with VoIP
Fundamentals (NN43001-260).
Press the Enter key.
Use the Right navigation key to scroll and highlight SET IP. Press
the Enter key to start the edit mode. Use the dialpad to fill in the
information:
Set IP—a valid IP Phone 1120E IP address
Use the Right navigation key to scroll and highlight NET MASK.
Press the Enter key to start the edit mode. Use the dialpad to fill
in the information:
Net Mask—a subnet mask
Use the Right navigation key to scroll and highlight Gateway. Press
the Enter key to start the edit mode. Use the dialpad to fill in the
information:
Gateway—the default gateway for the IP Phone 1120E on the LAN
segment to which it connects
Use the Right navigation key to scroll and highlight S1 IP. Press
the Enter key to start the edit mode. Use the dialpad to fill in the
information:
S1 IP—the primary CS 1000 node IP address for the IP Phone
1120E
Use the Right navigation key to scroll and highlight Port.
S1 Port—a fixed value of 4100
Use the Right navigation key to scroll and highlight S1 Action.
Press the Enter key to start the edit mode. Use the dialpad to fill in
the information. Choose one of the following
•
for TPS only, enter 1
• for TPS and Secure Media Controller, enter 6 or 1
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
Installation and configuration 325