First-Time Installation; Configuring The Ip Phone 2007 - Nortel 1110 Fundamentals

182 Nortel IP Phone 2007
•
•
•

First-time installation

You must first install an IP telephony node with the Communication Server.
For information about installing an IP telephony node, see Signaling Server
Installation and Commissioning (NN43001-312) or IP Line Fundamentals
(NN43100-500)
Configuring the IP Phone 2007
Procedure 34
Configuring the IP Phone 2007
Step
1
2
3
4
Copyright © 2003–2007, Nortel Networks
.
Ensure one Software License exists for each IP Phone 2007 you install.
Ensure the host Call Server is equipped with a Signaling Server that
runs the Line TPS application.
If you are not using Power over Ethernet (PoE) you must use the Global
power adapter or your phone fails to operate. See
2007 component list" (page
CAUTION
Damage to Equipment
Do not plug your IP Phone 2007 into an ISDN connection. Severe
damage can result.
Action
Configure a virtual loop on the system using LD 97.
For more information about configuring a virtual loop, see IP
Line Fundamentals (NN43100-500) and Software Input Output
Administration (NN43001-611).
Configure the IP Phone 2007 on the system using LD 11. At the
prompt, enter the following:
REQ:chg
TYPE:2007
To configure the IP Phone 2007 using LD 11, see Software Input
Output Administration (NN43001-611).
Connect the IP Phone 2007 components:
a. Connect one end of the handset cord to the handset jack on the
back of the IP Phone (identified with a handset icon).
b. Connect the other end of the handset cord to the handset.
Choose one of the following connections:
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
180).
Table 23 "IP Phone