Nortel 1110 Fundamentals page 152

152 Nortel IP Audio Conference Phone 2033
2
3
4
Copyright © 2003–2007, Nortel Networks
.
At the prompt, DHCP Yes/NO?, enter 0 (0 for No).
By default, Full DHCP is configured on the IP Audio Conference
Phone 2033. Depending on the configuration requirements, you can
change the IP Audio Conference Phone 2033 configuration to allow
the following IP address assignments:
• Static—enter all parameters
• Partial DHCP—IP Phone address, subnet mask, and default
Gateway are obtained from the DHCP server
• Full DHCP— (default) all parameters are obtained from the
DHCP server
A DHCP server and DHCP relay agents must also be installed,
configured, and running if you choose Partial DHCP, or Full DHCP
configuration.
For more information about how to set up DHCP servers for use
with the IP Phones, see Converging the Data Network with VoIP
Fundamentals (NN43001-260).
Enter the following information:
Screen prompt
set IP
net msk
def g w
The TFTP Server is required to download the current firmware. For
further information about TFTP Server configuration, see
"TFTP Server" (page 533)
Enter the information for the primary Connect Server (S1) and the
secondary Connect Server (S2):
Screen prompt
S1 IP
S1 Port
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
Description
a valid IP Audio Conference Phone 2033
IP address
a subnet mask
the default Gateway for the
IP Audio Conference Phone 2033 on the
LAN segment to which it connects.
Description
The primary CS 1000 node
IP address of the IP Audio
Conference Phone 2033.
This is a fixed value: 4100.
Appendix