Nortel 1110 Fundamentals page 158

158 Nortel IP Audio Conference Phone 2033
A tone sounds shortly before the IP Phone is ready to start the Nortel IP
Phone application. Once the application has loaded and started, the Nortel
logo and Starting DHCP appears at the bottom of the screen.
To edit network configuration, the following soft keys are available:
•
•
•
•
Procedure 27
Installing an IP Audio Conference Phone 2033 for the first time using DHCP
Step
1
2
3
Copyright © 2003–2007, Nortel Networks
.
OK—accept current settings and proceed to the next configuration
option. If all configuration options are presented, the configuration is
saved and the IP Phone reboots with the saved changes.
BkSpace—erase a configuration entry to change it
Clear—clear an entire configuration entry
Cancel—cancels network configuration. The IP Phone reboots without
saving changes.
Action
When the Nortel logo appears in the middle of the display,
immediately press the three soft keys at the bottom of the display in
sequence from left to right.
At the prompt DHCP Yes/No?, enter 1 (1 for Yes).
By default, Full DHCP is configured on the IP Audio Conference
Phone 2033. Depending on the configuration requirements, you can
change the IP Audio Conference Phone 2033 configuration to allow
the following IP address assignments:
• Static—enter all parameters
• Partial DHCP—IP Phone address, subnet mask, and default
Gateway are obtained from the DHCP server
• Full DHCP— (default) all parameters are obtained from the
DHCP server
A DHCP server and DHCP relay agents must also be installed,
configured, and running if you choose Partial DHCP, or Full DHCP
configuration.
For more information about how to set up DHCP servers for use
with the IP Phones, see Converging the Data Network with VoIP
Fundamentals (NN43001-260).
At the prompt, Cached IP?, select 0 (0-No, default) to conform to
the DHCP standard and to obtain an IP address from the DHCP
server. Only select 1 (1 for Yes) to force the IP Phone to start with
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007