Expansion Module For Ip Phone 1100 Series - Nortel 1110 Fundamentals

10

Expansion Module for IP Phone 1100 Series

The Expansion Module for IP Phone 1100 Series (Expansion Module) uses
the same TFTP Server configuration file method as the IP Phone 1120E, IP
Phone 1140E, and the IP Phone 1150E.
Table 76 "Fields in the TFTP configuration file for the Expansion Module"
(page 543)
The section [GEM FW] indicates the firmware is for the Expansion Module.
Set the download mode to AUTO or FORCED. It is recommended that you
set DOWNLOAD_MODE to AUTO.
Table 76
Fields in the TFTP configuration file for the Expansion Module
Field Name
[GEM FW]
DOWNLOAD_MODE
VERSION
FILENAME
PROTOCOL
SERVER_IP
SECURITY_MODE
After the IP Phone downloads the firmware from the TFTP Server, the
firmware is upgraded for any attached Expansion Modules, one at a time.
The Expansion Module verifies that the firmware was downloaded and
saved successfully before the IP Phone initiates the firmware download to
the next attached Expansion Module. If any errors occur, which prevent
Copyright © 2003–2007, Nortel Networks
.
If the IP Phone remains in this condition because no TPS FW
download occurs, check the TFTP IP address and the state of the
TFTP Server, then restart the IP Phone.
describes the fields in the configuration file on the TFTP Server.
Field Value
AUTO
FORCED
TFTP
xxx.xxx.xxx.xxx
0
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
Updating IP Phones firmware 543
—End—
Descriptions
Section header for the Expansion Module
firmware download information.
Recommended setting. The application looks
at the version and downloads the FW if it is a
newer version than the one on the phone.
The version of firmware is ignored. The
firmware is always downloaded.
The version string compared to the one on the
phone.
Image file name. This name must match the file
name of the actual IP Phone FW file.
Download protocol. This must be TFTP.
IP Address of the TFTP server in decimal.
For future use.