Installation And Configuration; Before You Begin; First-Time Installation - Nortel 1110 Fundamentals

Installation and configuration
The following sections provide a step-by-step guide to install and configure
the IP Phone 2007:
•
•
•
•
•

Before you begin

Before installing the IP Phone 2007, complete the following pre-installation
checklist:
•
•
•
•

First-time installation

You must first install an IP telephony node with the Communication Server.
For information about installing an IP telephony node, see Signaling Server
Installation and Commissioning (NN43001-312) or IP Line Fundamentals
(NN43100-500)
Copyright © 2003–2007, Nortel Networks
.
Before you begin
First-time installation
Configuring the IP Phone 2007
Startup sequence
Installing the IP Phone 2007
Ensure one IP Phone 2007 boxed package exists for each IP Phone
2007 being installed. The package contains:
— IP Phone 2007
— handset
— handset cord
— 2.1 m (7-ft) CAT5 Ethernet cable
— Getting Started Card
Ensure 1 Software License exists for each IP Phone 2007 being
installed.
Ensure the host Call Server is equipped with a Signaling Server that
runs the Line TPS application.
If you are not using Power over Ethernet (PoE) you must use the Global
power adapter or your phone fails to operate. See
2007 component list" (page
CAUTION
Damage to Equipment
Do not plug your IP Phone 2007 into an ISDN connection. Severe
damage can result.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
Installation and configuration 185
184).
Table 24 "IP Phone