First-Time Installation; Configuring The Ip Phone 2004; M (7-Ft) Cat5 Ethernet Cable - Getting Started Card - Nortel 1110 Fundamentals

110 Nortel IP Phone 2004
•
•
•

First-time installation

You must first install an IP telephony node with the Communication Server.
For information about installing an IP telephony node, see Signaling Server
Installation and Commissioning (NN43001-312) or IP Line Fundamentals
(NN43100-500).
Configuring the IP Phone 2004
Procedure 17 "Configuring the IP Phone 2004" (page 110)
the IP Phone 2002 for the first time.
Procedure 17
Configuring the IP Phone 2004
Step
1
2
Copyright © 2003–2007, Nortel Networks
.
— IP Phone 2004
— handset
— handset cord
— 2.1 m (7-ft) CAT5 Ethernet cable
— Getting Started Card
Ensure 1 Software License for each IP Phone 2004 being installed.
Ensure the host Call Server is equipped with a Signaling Server that
runs the Line TPS application.
If an AC power adapter is required, ensure you use the correct AC power
transformer. The voltage rating of the transformer must match the wall
outlet voltage. See Table 12 "IP Phone 2004 component list" (page
CAUTION
Do not plug your IP Phone 2004 into an ISDN connection. Severe
damage can result.
Action
Configure a virtual loop on the Call Server using LD 97.
For more information about configuring a virtual loop, see IP
Line Fundamentals (NN43100-500) and Software Input Output
Administration (NN43001-611).
Configure the IP Phone 2004 on the Call Server using LD 11. At
the prompt, enter the following:
REQ:chg
TYPE:2004P1,2004P2
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
108).
to configure