Nortel 1110 Fundamentals page 79

•
•
Procedure 10
Installing the IP Phone 2002 for the first time using manual configuration
Step
1
2
3
4
5
Copyright © 2003–2007, Nortel Networks
.
Clear—clear an entire configuration entry
Cancel—cancels network configuration. The IP Phone reboots without
saving changes.
Action
When the Nortel logo appears in the middle of the display,
immediately press the four soft keys at the bottom of the display in
sequence from left to right.
At the prompt EAP Enable?, enter 1-Yes (1 for Yes) if the network
infrastructure supports 802.1x port-based network access control.
Enter DeviceID and Password.
If you select No, you are not prompted to enter Device ID and
Password.
For more information about EAP, see
network access control" (page
At the prompt, LLDP Enable?, enter 1-Y (1 for Yes, default).
For more information about LLDP, see
Discovery Protocol" (page
see Appendix "802.1Q VLAN description" (page
At the prompt DHCP Yes/No?, enter 0-N (0 for No).
By default, Full DHCP is configured on the IP Phone 2002.
Depending on the configuration requirements, you can change
the IP Phone 2002 configuration to allow the following IP address
assignments:
• Static—enter all parameters
•
Partial DHCP—IP Phone address, subnet mask, and default
Gateway are obtained from the DHCP server
•
Full DHCP— (default) all parameters are obtained from the
DHCP server
A DHCP server and DHCP relay agents must also be installed,
configured, and running if you choose Partial DHCP, or Full DHCP
configuration. For more information about how to set up DHCP
servers for use with the IP Phones, see Converging the Data
Network with VoIP Fundamentals (NN43001-260).
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
Installation and configuration 79
Appendix "802.1x Port-based
455).
Appendix "802.1ab Link Layer
457). For more information about 802.1Q,
447).