Nortel 1110 Fundamentals page 421

Procedure 87
Connecting the Expansion Module to the IP Phone
Step
1
Copyright © 2003–2007, Nortel Networks
.
CAUTION
Damage to Equipment
To avoid damaging the equipment, remove the power (PoE
cable, or local power) from the IP Phone before connecting the
Expansion Module.
CAUTION
The Expansion Module is shipped with the base locked in position.
To avoid damaging the Expansion Module, press the wall-mount
lever, located on the base at the front of the Expansion Module.
Action
Press the tilt lever to adjust the stand angle on the IP Phone. See
Figure 51 "Wall-mount lever" (page
angle to maximum, instead of removing the stand. See
"Adjusting the stand angle on the IP Phone" (page
Figure 51
Wall-mount lever
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
Installation 421
421). You can adjust the stand
Figure 52
422).