Nortel 1110 Fundamentals page 524

Nortel communication server 1000
Hide thumbs Also See for 1110:
Table of Contents

Advertisement

524 Appendix G Bluetooth wireless technology
Procedure 130
Pairing the Bluetooth wireless technology headset with your IP Phone
Step
1
2
3
4
5
6
Copyright © 2003–2007, Nortel Networks
.
Action
Restart your IP Phone using one of the following methods
If you are using an AC power adapter, unplug it, wait 10 seconds,
and reinsert it.
If you are using POE, unplug the LAN Ethernet cable, wait 10
seconds, and reinsert it.
Double-press the Headset key to open the 3. Bluetooth Setup
dialog box.
The Enable Bluetooth check box is highlighted.
If the 3. Bluetooth Setup menu fails to open when you double press
the Headset key, Bluetooth wireless technology is not enabled on
your phone.
Press the Enter key to activate Bluetooth wireless technology.
A check mark is displayed to indicate that Bluetooth wireless
technology is activated. The message BT Enabled appears at the
bottom of the display.
Put your Bluetooth wireless technology headset in its pairing or
search mode. The procedure for doing this can be different for each
wireless headset. See the documentation that accompanies your
headset.
Search for the headset.
a. Press the Right navigation key twice to highlight the Search
button, displayed next to the Search Devices item.
b. Press the Enter key.
The message Searching... is displayed.
c. If the search is successful, a list of Bluetooth wireless technology
headsets appears in the Found: box.
d. Choose one of the following
If the search is successful, proceed to step 6.
If the search is not successful, the message Search
completed. No device found is displayed. Power off the
wireless technology, and repeat step 4 and step 5.
Wait for the search to finish or press the Stop soft key to end the
search.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007

Advertisement

Table of Contents
loading

Table of Contents