Removing An Ip Audio Conference Phone 2033 From Service; Connecting An Extension Microphone - Nortel 1110 Fundamentals

168 Nortel IP Audio Conference Phone 2033
4

Removing an IP Audio Conference Phone 2033 from service

Procedure 32
Removing an IP Audio Conference Phone 2033 from service
Step
1
2

Connecting an extension microphone

Procedure 33
Connecting an extension microphone to the IP Audio Conference Phone 2033
Step
1
2
Copyright © 2003–2007, Nortel Networks
.
(page 151) or Procedure 28 "Enable Full Duplex mode" (page 165)
to install and configure the IP Audio Conference Phone 2033.
Enter the same TN and Node Number as the IP Audio Conference
Phone 2033 you replaced. The system associates the new IP Audio
Conference Phone 2033 with the existing TN.
Action
Disconnect the IP Audio Conference Phone 2033 from the network
or turn off the power.
If the IP Audio Conference Phone 2033 was automatically
configured, the DHCP lease expires and the IP address returns to
the available pool.
In LD 11, enter OUT at the TN prompt.
Action
Thread the microphone cord through the channels on the bottom of
the IP Phone.
A maximum of two microphone jacks are supported on the IP Audio
Conference Phone 2033.
Connect the microphone cord to one of the microphone jacks on the
bottom of the IP Phone.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
—End—
—End—
—End—