Nortel 1110 Fundamentals page 422

422 Expansion Module for IP Phone 1100 Series
2
3
Copyright © 2003–2007, Nortel Networks
.
Figure 52
Adjusting the stand angle on the IP Phone
At the back of the IP Phone, remove the rubber plug from the
Accessory Expansion Module (AEM) port. Place the connecting
arm of the Expansion Module behind the IP Phone and align the
Expansion Module connection plug to the AEM port on the back of
the IP Phone.
Insert the screws in to the top and bottom holes of the connecting
arm of the Expansion Module and tighten until snug. See
"Connecting the Expansion Module" (page
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
Figure 53
423).