Nortel 1110 Fundamentals page 231

Procedure 43
Installing an IP Softphone 2050 for the first time
Step
1
2
3
4
5
6
7
Copyright © 2003–2007, Nortel Networks
.
Action
Install the Voice Gateway Media Card. For more information, see IP
Line Fundamentals (NN43100-500).
Configure a virtual loop on the Call Server, using LD 97.
For more information, see Software Input Output Administration
(NN43001-611).
Configure the IP Softphone 2050 using LD 11. At the prompt, enter
the following
REQ: chg
TYPE: 2050PC
Install the USB Headset Adapter. If you are using the mobile
adapter, connect the headset to the adapter. If you are using the
desktop adapter, you must
a. Connect the coiled lower cord to the headset cord with the Quick
Disconnect connector. Ensure the Quick Disconnect connector
is securely fastened.
b. Connect the headset cord to the RJ9 jack on the adapter.
Connect the USB cable to the headset adapter and to one of the
USB jacks on the back of your PC or USB hub.
The first time the headset adapter is plugged in, a delay occurs while
Windows configures the device and locates the appropriate driver
softw are. During the installation, you are prompted to supply the
original Windows CD-ROM so Windows can locate the required
drivers.
Install the IP Softphone 2050.
Configure the IP Softphone 2050 parameters. Click the Server tab
in the Settings window and choose one of the following
• To manually configure the IP Softphone 2050 parameters, enter
the IP address of the Call Server, Server type, port number, and
retries.
• For DHCP, select the check box beside Automatic (DHCP).
The IP address, Server type, port number, and retries are
automatically retrieved from the DHCP Server.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
First-time installation 231