Configuring The Ip Phone 2001 - Nortel 1110 Fundamentals

First-time installation
You must first install an IP telephony node with the Communication Server.
For information about installing an IP telephony node, see Signaling Server
Installation and Commissioning (NN43001-312) and IP Line Fundamentals
(NN43100-500).
Configuring the IP Phone 2001
Use
the IP Phone 2001 for the first time.
Procedure 1
Configuring the IP Phone 2001
Step
1
2
3
4
5
Copyright © 2003–2007, Nortel Networks
.
CAUTION
Do not plug your IP Phone 2001 into an ISDN connection. Severe
damage can result.
Procedure 1 "Configuring the IP Phone 2001" (page 41)
Action
Configure a virtual loop on the Call Server using LD 97.
For more information about configuring a virtual loop, see IP
Line Fundamentals (NN43100-500), and Software Input Output
Administration (NN43001-611).
Configure the IP Phone 2001 on the Call Server using LD 11. At
the prompt, enter the following:
REQ:chg
TYPE:2001P2
For more information about configuring the IP Phone 2001 using LD
11, see Software Input Output Administration (NN43001-611).
Connect the IP Phone 2001 components:
a. Connect one end of the handset cord to the handset jack on the
back of the IP Phone identified with a handset icon.
b. Connect the other end of the handset cord to the handset.
Connect one end of the CAT5 Ethernet cable to the network interface
located on the back of the IP Phone (identified with a LAN icon, see
Figure 3 "IP Phone 2001 Ethernet network interface connections"
(page 42)). The other end of the CAT5 Ethernet cable plugs into
the IP network.
Connect the AC power adapter (optional). Leave the AC adapter
unplugged from the power outlet, connect the adapter to the AC
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
Installation and configuration 41
to configure