First-Time Installation; Configuring The Ip Phone 2002 - Nortel 1110 Fundamentals

•
•
•

First-time installation

You must first install an IP telephony node with the Communication Server.
For information about installing an IP telephony node, see Signaling Server
Installation and Commissioning (NN43001-312) orIP Line Fundamentals
(NN43100-500).
Configuring the IP Phone 2002
Use
the IP Phone 2002 for the first time.
Procedure 9
Configuring the IP Phone 2002
Step
1
2
3
Copyright © 2003–2007, Nortel Networks
.
Ensure 1 Software License exists 1 for each IP Phone 2002 being
installed.
Ensure the host Call Server is equipped with a Signaling Server that
runs the Line Terminal Proxy Server (LTPS) application.
If an AC power adapter is required, ensure you use the correct AC power
transformer. The voltage rating of the transformer must match the wall
outlet voltage. See Table 8 "IP Phone 2002 components list" (page
CAUTION
Do not plug your IP Phone 2002 into an ISDN connection. Severe
damage can result.
Procedure 9 "Configuring the IP Phone 2002" (page 75)
Action
Configure a virtual loop on the Call Server using LD 97.
For more information about configuring a virtual loop, see IP
Line Fundamentals (NN43100-500) and Software Input Output
Administration (NN43001-611).
Configure the IP Phone 2002 on the Call Server using LD 11. At
the prompt, enter the following:
REQ:chg
TYPE:2002P1,2002P2
For more information about configuring the IP Phone 2002 using LD
11, see Software Input Output Administration (NN43001-611).
Connect the IP Phone 2002 components:
a. Connect one end of the handset cord to the handset jack on the
back of the IP Phone (identified with a handset icon).
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
Installation and configuration 75
to configure
73).