Nortel 1110 Fundamentals page 297

9
10
Copyright © 2003–2007, Nortel Networks
.
You are prompted to enter the TFTP Server IP address if you are
using a TFTP Server to download the current firmware.
The method to upgrade the firmware depends on the following Call
Server software
•
For CS 1000 Release 4.0, the TFTP Server is required to
download the current firmware. Enter the TFTP Server IP
address at the prompt.
• For CS 1000 Release 4.5, use either a TFTP Server to upgrade
the firmware (at the prompt accept the default entry of 0.0.0.0) or
UFTP to download the current firmware.
• For CS 1000 Release 5.0, a Signaling Server provides the
firmware for the IP Phones. Check the Nortel Web site at
www.nortel.com
For CS 1000 Release 4.0, the IP Phone 1110 searches for the TFTP
Server for firmware upgrade. If the file name specified in 1110.cfg is
not the same as the current firmware, the IP Phone downloads the
file and upgrades the firmware. This takes several minutes. When
the upgrade is complete, the IP Phone 1110 reboots.
For further information about TFTP Server configuration, see
Appendix "TFTP Server" (page
The Enhanced UNIStim firmware download is supported on CS 1000
Release 4.5 or later. The Enhanced UNIStim firmware download
feature for IP Phones improves the delivery of new firmware to IP
Phones. For further information about Enhanced UNIStim Firmware
Download, see IP Line Fundamentals (NN43100-500).
For information about the IP Phone firmware upgrade using Element
Manager, see Element Manager System Reference—Administration
(NN43001-632).
The IP Phone 1110 can support primary (S1) and secondary (S2)
connect server. If you require IP Phones to register on multiple
nodes, see IP Line Fundamentals (NN43100-500).
The IP Phone 1110 saves the configuration and then reboots. The
IP Phone 1110 searches for the connect server.
The IP Phone 1110 registers with the TPS and, if needed, begins the
firmware download. This takes several minutes. When registration is
complete, the IP Phone 1110 resets.
The current Call Server date and time appear on the top line of the
display when the configuration is complete. Self-labeling keys also
appear.
Check for a dial tone and the correct DN above the display.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
Installation and configuration 297
for updated firmware files.
533).