Nortel 1110 Fundamentals page 42

42 Nortel IP Phone 2001
6
7
Copyright © 2003–2007, Nortel Networks
.
adapter jack in the bottom of the phone. Form a small bend in the
cable and then thread the adapter cord through the channels in
the stand.
Secure the IP Phone footstand to the base of the IP Phone. Use
the angle adjustment grip on the top back of the IP Phone to adjust
the position.
CAUTION
Damage to Equipment
Do not plug any device into your IP Phone 2001 Ethernet
port other than one PC.
Figure 3
IP Phone 2001 Ethernet network interface connections
Power the IP Phone 2001 using either the Power over Ethernet or an
AC power transformer (local power). If you are using local power,
plug the AC power transformer into the nearest power outlet. Make
sure you use the correct AC power transformer is used. The voltage
rating of the transformer must match the wall outlet voltage. See
Table 4 "IP Phone 2001 components list" (page
The IP Phone 2001 supports both AC power and Power over LAN
options, including IEEE 802.3af Power Classification 2. To use
Power over Ethernet, where power is delivered over the CAT5 cable,
the LAN must support Power over Ethernet, and an AC adapter is
not required. To use local AC power, the optional AC adapter can be
ordered separately.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
39).