Nortel 1110 Fundamentals page 163

Copyright © 2003–2007, Nortel Networks
.
PSK SRTP? (0 for No, 1 for Yes)
GARP Ignore? (0-No,1-Yes)
You are prompted to enter the TFTP Server IP address if you are
using a TFTP Server to download the current firmware.
The method to upgrade the firmware depends on the following Call
Server software:
• For Succession Release 3.0 or CS 1000 Release 4.0, the TFTP
Server is required to download the current firmware. Enter the
TFTP Server IP address at the prompt
•
For CS 1000 Release 4.5, use either a TFTP Server to upgrade
the firmware (at the prompt accept the default entry of 0.0.0.0) or
UFTP to download the current firmware.
•
For CS 1000 Release 5.0, a Signaling Server provides the
firmware for the IP Phones. Check the Nortel Web site at
www.nortel.com
For Succession Release 3.0 and CS 1000 Release 4.0, the IP Audio
Conference Phone 2033 searches for the TFTP Server for firmware
upgrade. If the file name specified in i2033.cfg is not the same as
the current firmware, the IP Phone downloads the file and upgrades
the firmware. This takes several minutes. When the upgrade is
complete, the IP Audio Conference Phone 2033 reboots.
For further information about TFTP Server configuration, see
Appendix "TFTP Server" (page
The Enhanced UNIStim firmware download is supported on CS 1000
Release 4.5 or later. The Enhanced UNIStim firmware download
feature for IP Phones improves the delivery of new firmware to IP
Phones. For further information about Enhanced UNIStim Firmware
Download, see IP Line Fundamentals (NN43100-500).
For information about the IP Phone firmware upgrade using Element
Manager, see Element Manager System Reference—Administration
(NN43001-632).
The IP Audio Conference Phone 2033 can support primary (S1) and
secondary (S2) connect server. If you require IP Phones to register
on multiple nodes, see IP Line Fundamentals (NN43100-500).
The IP Audio Conference Phone 2033 searches for the connect
server.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
Installation and configuration 163
Default 0 (for No).
Default 0 (for No).
for updated firmware files.
533).