Nortel 1110 Fundamentals page 92

92 Nortel IP Phone 2002
Copyright © 2003–2007, Nortel Networks
.
Screen prompt
Data VLAN Cfg? (0-Auto,
1-Man)
Data VLAN ID:
Data pBits (0-7, 8-Au)
PCUntagAll? (0-N, 1-Y)
PSK SRTP? (0-No, 1-Yes)
GARP Ignore?
(0-No,1-Yes)
The IP Phone 2002 supports remote firmware upgrades through a
TFTP process and an automated UFTP process.
You are prompted to enter the TFTP Server IP address if you are
using a TFTP Server to download the current firmware.
The method to upgrade the firmware depends on the following Call
Server software:
•
For Succession Release 3.0 or CS 1000 Release 4.0, the TFTP
Server is required to download the current firmware. Enter the
TFTP Server IP address at the prompt
• For CS 1000 Release 4.5 and later, use either a TFTP Server to
upgrade the firmware (at the prompt accept the default entry of
0.0.0.0) or UFTP to download the current firmware.
For Succession Release 3.0 and CS 1000 Release 4.0, the IP Phone
2002 searches for the TFTP Server for firmware upgrade. If the file
name specified in i2002.cfg is not the same as the current firmware,
the IP Phone downloads the file and upgrades the firmware. This
takes several minutes. When the upgrade is complete, the IP Phone
2002 reboots.
For further information about TFTP Server configuration, see
Appendix "TFTP Server" (page
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
Description
Default 1 (for Man)
You are not prompted for Data VLAN Cfg
if LLDP or Data VLAN are not enabled
and PC Port is set to 0 for Off.
If you select 0 (for Auto), VLAN ID is
automatically configured to the value
received in the VLAN NAME TLV.
You are not prompted for Data VLAN ID if
Data VLAN is set to 0 for Auto.
Default 8 (for Au).
You are not prompted for Data pBits if the
PC Port is set to 0 for Off or if 802.1Q is
not enabled.
Default 0 (for No).
Default 0 (for No).
Default 0 (for No).
533).